# # Default relayd.conf file for Pleroma on OpenBSD # Simple installation instructions: # 1. Place in /etc # 2. Replace <ipaddr> with your public IPv4 address # 3. If using IPv6i, uncomment IPv6 lines and replace <ip6addr> with your public IPv6 address # 4. Check file using 'doas relayd -n' # 5. Reload/start relayd # # doas rcctl enable relayd # # doas rcctl start relayd # ext_inet="<ipaddr>" #ext_inet6="<ip6addr>" table <pleroma_server> { 127.0.0.1 } table <httpd_server> { 127.0.0.1 } http protocol plerup { # Protocol for upstream pleroma server #tcp { nodelay, sack, socket buffer 65536, backlog 128 } # Uncomment and adjust as you see fit tls ciphers "ECDHE-ECDSA-AES256-GCM-SHA384:ECDHE-RSA-AES256-GCM-SHA384:ECDHE-ECDSA-CHACHA20-POLY1305:ECDHE-RSA-CHACHA0-POLY1305" tls ecdhe secp384r1 # Forward some paths to the local server (as pleroma won't respond to them as you might want) pass request quick path "/robots.txt" forward to <httpd_server> # Append a bunch of headers match request header append "X-Forwarded-For" value "$REMOTE_ADDR" # This two header and the next one are not strictl required by pleroma but adding them won't hurt match request header append "X-Forwarded-By" value "$SERVER_ADDR:$SERVER_PORT" match request header append "Connection" value "upgrade" } relay wwwtls { listen on $ext_inet port https tls # Comment to disable listening on IPv4 # listen on $ext_inet6 port https tls # Comment to disable listening on IPv6 protocol plerup forward to <pleroma_server> port 4000 check http "/" code 200 forward to <httpd_server> port 80 check http "/robots.txt" code 200 }